Engine-Tech

Categories

Snowmobiles-> (10)
Sea-Doo PWC (2)
Yamaha PWC (7)

Articles

ET SEADOO SUPERCHARGER KITS
IMPELLER MACHINING
-- YAMAHA FX SHO S/C --
141 MPH Single pipe F9
8.7 151MPH RECORD HOLDING SLED
WWW.ETECHZONE.NET

Shopping Cart

0 items

Quick Find

Use keywords to find the product you are looking for.
Advanced Search

Information

Conditions of Use
Contact Us

My Account | Cart Contents | Checkout

Top » Catalog » Yamaha PWC »

FX SHO /FZR/FZS High Boost

$649.00

Click to enlarge

Supercharger impeller

Yamaha SHO Engine-Tech S/C Wheel

ET Xtreme billet Supercharger

Yamaha SHO FZR FZS S/C High Boost

Engine-tech has been working on this project for quite some time and is now complete. The results are outstanding 15.5 lbs of boost @ 8350 rpm. Machined from billet 7075-T651 using a 5 axis cnc machining center allows a blade accuracy of .001.Balance to a spec of .009 inch gram and comes completely anodized gold for protection against the elements(corrosion resistant).This new Engine-Tech S/C impeller is the lightest on the market and lighter than stock by 17% This will help the clutch longevity.The performance gains are: Arm wrenching acceleration usefull for drag or closed course racing and radar runs .This Supercharger comes with a fuel map that can be loaded in the Motec ECU and setup spec's.

Dyno tested at Motec's dyno this Supercharger wheel makes the most Hp at 348hp at 8500rpm and the most boost on the maket today!

Requires: Rising rate fuel presure regulator, High flow intercooler, Motec or a aftermarket ECU.

Important a "HSK" blow off valve required to releeve stress off the clutch.

Price is 649.00

Installing a S/C wheel in the yamaha's are a delicat job and should be treated as one. In the assemble stage make sure you use plenty of Clean and good quality oil.
After you have assembled the charger. DO NOT start the engine until you have primed the charger with oil.
(There is a bleeder bolt on top of the charger. Remove the bolt and fill (Prime) with good quality oil).
After you have done this and you are ready to start the engine. DO NOT REV THE ENGINE FOR AT LEAST A GOOD 60 SECONDS.

If you do not follow this and Rev your engine on the stand before your Supercharger has OIL PRESSURE then you may wear your charger bearings out in a mater of seconds. (Damage the shaft and other rotating parts)

The FZR Supercharger spins 10 times the engine RPM.

Example engine 6,000rpm = 60,000rpm

There are some reports that some like to rev there engine out of the water after assemble, not a good idea.

There are new bearings available with the oil update (grove) and will be coated with a hard molly. Still requires oil pressure to take advantage of this new product so make sure you follow these step for a trouble free ride.

Art

This product was added to our catalog on Thursday 27 August, 2009.